Wednesday, March 12, 2014

Replacing Well Pump And Unlocking Pitless Adapter



My submersible pump was over 20 years old, not supplying enough water to flush the toilet and take a shower along with blowing the circuit breaker on occasion. It was down 60 feet and I had to figure out unlock the pitless adapter before I could pull out the well.
The pitless adapter was made by Wells Inc. in Ohio and can be unlocked by making a tool using a 6 foot, 1/2 steel pipe. Take the pipe, flatten one end leaving enough clearance for the inside to fit over a wingnut and make a handle on the opposite end. The flattened end goes down the 1 pipe that suspends the well and by turning counterclockwise the pitless adaper foot will go down. Make sure the water and pump is turned off before doing this.
The well was pulled out using 2 U brackets and a come-a-long suspended from an extension ladder leaning against a tree. This method can bring the ell up at about 3 feet at time before needing to reposition the brackets which I used to hold the well on the side of the 4 well casing.






Tags: pump, pitless, adapter, pitless adapter